Zilog ZAURCT Instrukcja Użytkownika Pobierz pdf (Strona 32)

UM022903-0311 ZAURA System Installation and Configuration

ZAURA

™

RF Wireless Lighting Control

Installation Guide

If the battery becomes too weak for the Master to continue operating, the Master will no

longer control the lamps; however, the lamps can be controlled in the traditional way using

the light switch. After you install a fresh battery, the Master will resume control of the

lamps.

Set Up and Install ZAURA Virtual Dimming Luminaries

Virtual dimming is triggered in the ZAURA Detector when natural light exceeds a pre-

determined level that can be adjusted by the Light Sensitivity POT. If natural light is not a

factor in your room installation, or if no Virtual Dimming Luminaries are to be used, skip

this section and proceed to the Set Up and Install ZAURA Standard Luminaries

section on

page 29. For a more thorough description of virtual dimming, see the Light Sensor for

Daylight Harvesting section on page 6.

The following precautions must be observed when working with the devices described

in this section.



• When replacing Starters, it is necessary to turn off the main power to the luminaries



• Be sure to match starter wattage with lamp wattage



• Install and use in accordance with applicable electronic codes and regulations

To install the ZAURA Starters in the Virtual Dimming Luminaries, observe the following

steps.

1. Turn off line power to the luminaries.

2. Remove the fixture cover and lamp(s), if necessary.

3. Remove the old starter by gently pushing it in and turning it counterclockwise.

4. Insert a ZAURA Starter by gently pushing it and turning it clockwise. Refer to

Figure 21 for starter installation examples.

Note:

Caution:

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 58 59

Brak uwag

Zilog ZAURCT Instrukcja Użytkownika Strona 32