Zilog Z8FS021A Instrukcja Użytkownika Pobierz pdf (Strona 13)

UM023302-1214 9

ZMOTION

Intrusion Detection Development Kit

User Manual

In the above output, when power is applied to the Board, it sends a title message and the

software version, then waits for the pyroelectric sensor to stabilize, which can take

between 10 and 60 seconds. A ‘.’ symbol is transmitted every second while it waits for sta-

bility. After the pyroelectric sensor becomes stable, the software is ready to start detecting

motion. Each time a motion event is detected, a message is transmitted. For example, in

the message M 001 @ 33, the character indicates which part of the ZMOTION Engine

detected the motion event. M indicates the event was detected by the Normal Engine and

E indicates the Extended Engine detected the motion event. 001 is the count of motion

events for each Engine and 33 is the time of the event in seconds since power-on.

Connecting the USB SmartCable

Observe the following steps to connect the USB SmartCable to the ZMOTION Develop-

ment Board.

The power to the development board must be disconnected or turned OFF before con-

necting or disconnecting the USB Smart Cable.

1. Attach one end of the six-conductor ribbon cable (included) to the USB SmartCable

six-pin DBG connector, as shown in Figure 3.

2. Attach the free end of the ribbon cable to the DBG connector (ZDI Interface) on the

development board. Ensure that pin 1 on the ribbon cable (indicated by the dark stripe)

is aligned with pin 1 on the target connector (indicated by a

1 on P2 of the board).

Figure 3. Connecting the Six-Conductor Ribbon Cable to the USB Smart Cable

Caution:

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Brak uwag

Zilog Z8FS021A Instrukcja Użytkownika Strona 13